Solution Summary: Panel Gripper
A panel gripper is an engineering control that can help reduce musculoskeletal disorders (MSD) from stooping and stressful hand and wrist activities. It is a tool used to carry various building materials, including plywood, particle board, sheet metal, ducts, glass, and granite. The device is made of aluminum and has a comfort grip handle. Two metal plates with rubber grip pads tighten around the desired material to ease lifting tasks.
The Gorilla Gripper® can be used on building material from 3/8” - 1 1/8” thick. The metal plates are placed on opposite sides of the material, and a worker can then lift up on the handle to tighten the grip. The material can then be easily lifted and carried to the desired location.
Figure 1. Close up view of worker using the Gorilla Gripper
Heavy lifting and carrying and stooped postures can cause low back disorders, such as muscle strain or a disc herniation (“slipped disc”), which is bulging of disc material possibly pressing on the spinal cord or nerves that go into the leg. The panel gripper can help reduce MSDs caused by heavy lifting and carrying and stooped postures by creating a safer way to pick up and carry heavy panels.
Stressful hand and wrist activity can cause musculoskeletal disorders (MSDs) such as muscle strains; tendonitis, which is inflammation of elbow and wrist tendons; or carpal tunnel syndrome, which is compression of a wrist nerve, resulting in finger numbness and loss of hand strength. The panel gripper can help reduce stressful hand and wrist activity by adding a comfortably shaped and safely positioned carrying point to heavy panels.
How Risks are Reduced:
The design of the Gorilla Gripper® eliminates the need for workers to manually handle and carry building materials. Instead of grasping the material with their hands, a worker only has to hold onto the handle of the Gorilla Gripper®. Using the Gorilla Gripper® decreases the need to be in a stooped posture during lifting tasks. For example, a worker would normally need to stoop when lifting plywood to grasp both edges of the sheet. With the Gorilla Gripper®, the sheet can be lifted with a grip on only one edge. Due to the design of the Gorilla Gripper®, materials are able to be held closer to the body which decreases stress on the entire arm and low back.
Manufacturers report that the Gorilla Gripper® reduces strain on the back, neck, shoulders, and arm. When carrying large sheets of plywood, sheetrock, or metal without the Gorilla Gripper®, a worker may carry the material above or away from the body. The Gorilla Gripper® allows the material to be held from waist to shoulder height and close to the body, which helps the worker maintain a neutral spine position. Reviews from customers indicate that the Gorilla Gripper® makes lifting easier, reduces fatigue, and may help to decrease incidence of injury.
Effects on Productivity:
Using the Gorilla Gripper® may increase productivity due to decreased worker fatigue and time spent on lifting tasks.
The Gorilla Gripper® changes the mechanics of carrying building materials. The tool may help a worker maneuver in tight spaces, maintain an unobstructed view, and reduce the risk of sustaining cuts from sharp edges.
Dan Anton, PT, PhD, ATC – Eastern Washington University
- Remove commercial carpet
- Drywall, Glass & Floor Coverings
- Move and install drywall or panels
- General Labor
- Remove commercial carpet
- Masonry, Tile, Cement & Plaster
- Lay or set brick, block, or stone
- Residential Construction